![]() 11.61 G425: Perform auto-calibration with calibration cube.11.55 G130: Set digital potentiometer value.11.54 G100: Calibrate floor or rod radius.11.51 G94: Feed Rate Mode (Units per Minute) (CNC specific).11.50 G93: Feed Rate Mode (Inverse Time Mode) (CNC specific).11.49.1 G92.x: Reset Coordinate System Offsets (CNC specific).11.45 G87: Enable babystep correction after home.11.44 G86: Disable babystep correction after home.11.42 G84: UNDO Babystep Z (move Z axis back).11.41 G83: Babystep in Z and store to EEPROM.11.40 G82: Single Z probe at current location.11.37 G80: Cancel Canned Cycle (CNC specific).11.36 G76: PINDA probe temperature calibration.11.35 G75: Print temperature interpolation.11.32 G60: Save current position to slot, Restore and Delete.11.31 G53.59: Coordinate System Select (CNC specific).11.29 G40: Compensation Off (CNC specific).11.28.4 G38.5 probe away from workpiece, stop on loss of contact.11.28.3 G38.4 probe away from workpiece, stop on loss of contact, signal error if failure.11.28.2 G38.3 probe toward workpiece, stop on contact.11.28.1 G38.2 probe toward workpiece, stop on contact, signal error if failure.11.28 G38.x Straight Probe (CNC specific).11.27 G34: Calculate Delta Height from toolhead position (DELTA).11.25.2 G33: Delta Auto Calibration (Marlin 1.1.x - MK4duo).11.25.1 G33: Measure/List/Adjust Distortion Matrix (Repetier - Redeem).11.23.2 Probe and calculate in Repetier firmware.11.23.1 Probe and calculate in Reprapfirmware.11.23 G32: Probe Z and calculate Z plane. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |